Eclipse Combustion F8000 Series Service/ Instrukcje Operacyjne Pobierz pdf (Strona 17)

2-3

3. HYDRAULIC POWER UNIT

a. Unit Mounting

CAUTIONS

THE HYDRAULIC POWER UNIT MUST BE LOCATED SO THAT:

C THE DOOR ON THE PUMP ENCLOSURE MUST OPEN/CLOSE FREELY WITH

NO OBSTRUCTIONS.

C THE MANUAL PUMP HANDLE MUST BE ACCESSIBLE AND OPERABLE.

C THE OPERATOR HAS AN UNOBSTRUCTED VIEW OF THE PLATFORM

SURFACE WHILE OPERATING THE MANUAL BACK-UP SYSTEM.

C The design capacity of the bracketry used to mount the hydraulic power unit must meet

the criteria listed in Table [2-2]. These criteria will ensure that the pump mounting will

withstand loads applied during manual pump operation.

TABLE [2-2]: HYDRAULIC POWER UNIT BRACKET LOAD CAPACITIES

LOADING DIRECTION BRACKET CAPACITY

Vertical 125 lbs

Longitudinal (perpendicular to vehicle drive axles) 200 lbs

Lateral (parallel to vehicle drive axles) 100 lbs

END OF TABLE

b. Unit-to-Cylinder Connection

1. Connect the main hydraulic hose to the hydraulic power unit if not already done.

2. Operate the manual backup pump until hydraulic fluid flows out of the open end of the

main hydraulic hose.

3. Lower the platform to ground level.

4. Remove the plug on the top of the hydraulic pump tank. Make sure that the hydraulic

fluid in the tank is at the FULL level. Fill only with Texaco No. 15 aircraft hydraulic fluid

(or equivalent U.S. mil spec H5606E/F oil) and reinstall the plug.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 76 77

Brak uwag

Eclipse Combustion F8000 Series Service/ Instrukcje Operacyjne Strona 17